Is it feasible to determine whether or not a magnetic frame is saturated by the following experiment?
Device: A small solenoid, approx 1.5inch by 2.0inch.
Method:
The solenoid is secured in a non-magnetic fixture.
The armature position is fixed half way along its stoke. [full stroke approx...
Good Morning,
I’ve read somewhere that “ theoretically, the peak voltage that is generated when you disconnect a coil form its supply, without suppression of any kind, may be infinite”.
If it is theoretical then, I guess, there must be a recognised formula that can be applied. I done the...
Hi Folks,
I have a compression spring that has been affect by heat.
Is it correct to say that the spring has been "distempered" or is it more correct to say "de-tempered"?
I would appreciate your comments.
Regards,
Hi,
I’m using a PUT [2N6068] to trigger a Thyristor or SCR [C106D1] as follows:-
Circuit A:
+Veo-+-------------+------------------+
| | |
/ / |
R1 \ R2 \ |...
Hi Forum,
Can anyone provide me (or point me in the right direction) with a ball park figure for the Reluctance of ENIA steel?
I have contacted and questioned our materials supplier, unfortunately they don’t have the information I require, but they have supplied me with a magnetic properties...
Hi,
Although it is known that the heating effect of DC is equal to AC at the same RMS, can anyone point me to any publications or references that substantiate this?
Thanks in advance.
