Being a mech eng primarily, I am diving into an area that I know only a little about, but I was wondering if someone could point me in the direction of some good references that would allow me to learn more about environmental stress screening of surface mount technology/devices. I am...
I confess that I am not an expert in HVAC, more of a general ME, so I'd like your help. Can anyone give me a list of possible causes for higher than expected compressor discharge pressures on a refrigeration system?
Causes that come to my mind are:
1. Refrigeration overcharge
2. Too much oil...
Being an ME, I need some EE help. Can I reliably run one of those new tankless water heaters (essentially a big resistor), which draws 30A at 240Vac, from a 240Vac, 30A, 3 phase supply? Or will I be constantly tripping power?
Thanks,
Tim
Hello,
Is there a degrading effect (maybe beneficial?) from repeated cycles of heat treating? For example, I have a friend that is trying to achieve a specified hardness in 4130 steel and the first attempt didn't quite get to the level he wanted. Is there any problem with trying again?
Also...
