Hello
We have a big project,that will need many panel boards.We are planning to build our fabrication plant.Could you advice what are the main machinary,equipment and tools required for this plant.
Thank you
We have a 75 HP motor(400v,50Hz,FLA=105A)operated through a solid state starter(soft starter),usually working on the utility grid powr supply.
We tried to connect it to a standby diesel generator of 150 KVA rating,the generator failed to start the motor.
The strange thing with this motor that we...
We are desining a water pump station that feeds regional reservoirs.Those reservoirs are spaced about 10-16 Km from the pump station.There is no power source available or close to the reservoirs sites.How can we install and operate the control system for starting and stopping the pumps by a...
We have experienced a noise problem with the motor that drives a vertical turbine can pump.After disassembling the motor it appeared that the rotor was touching/scratching the stator.Some opinions say that its because of the improper sized thrust bearing,but no clear cause is finalized.
My worry...
