I'm working with A356-T6 Al that has a normal operating temp of 100 degrees C but can go up to 200 degrees C for at most 10 minutes at a shot. My ASM Book Aluminum Alloy Castings Properties, Processes and Applications book has a table (D4.26) that shows 356-T6 material properties at elevated...
I have a little rubber boot made of Nitrile, that I'm designing, that fits over a plastic cover for an electrical connection. What type of interference values should I use to keep it on the cover.
Thanks,
Will
I have a little rubber boot made of Nitrile, that I'm designing, that fits over a plastic cover for an electrical connection. What type of interference values should I use to keep it on the cover.
Thanks,
Will
I'm switching the grommets that we design from a rubber material to a thermo plastic elastomer with 400% or so elongation. My question is how do I mechanically remove the gating after the mold opens. Presently the rubber that we use is hand trimmed. Are there any manufactures, tooling companies...
Within the next couple of days I will try molding some grommets out of a product called Finaprene (www.autofina.com) it's a thermo plasic elastomer. We like the %elongation we can get and the regrind abilities. However no won here has ever used this material. Is there any additives, molding...
Within the next couple of days I will try molding some grommets out of a product called Finaprene (www.autofina.com) it's a thermo plasic elastomer. We like the %elongation we can get and the regrind abilities. However no won here has ever used this material. Is there any additives, molding...
