I just pulled a dxf off of one of our suppliers web sites in dxf format. when I pull up the drawing (in dwg format) and try to get a diminsion between two holes it comes out in cm. In the dim style manager box, under primary units the unit format is Decimal. My question is how do I made my...
Is it possible when in the draft enviroment to create on hole table, on a seperate page for all of the previous views/pages. For example I am working on a 4 page drawing. I have a front, left , right, and top view. I want to add a page 5 with a hole table for all the previous pages. Any help...
Using solid edge 14 service pack 5. I get a grey arrow pointing to a cutout when I go back before that cut out and make a change to a profile I am getting this error message a lot. the cutout or protrusion that I get an error on seems to me to be non associative to the one I modify but I still...
I just up graded SE11 to SE14 and the first thing I noticed was WOW, THOSE ARE SOME BIG OLE BUTTONS!! :-) Is there any way to make them smaller, I know that their was in SE11 but I either can't remember it or can't find it.
Thanks,
DKDragon
What is it that you go in and change so that when in an assembly, and adding a part from the pathfinder you do not have to specify any relationships, just choose the arrow tool and SE grounds the part, even if its not the first part placed?
Thanks,
Dkdragon
Say I made a drawing "control1" and put it in a folder named "one". I create a draft of "control1", completly deminsion it, save and close it. Later I move "control1" to a folder named "five". Now when I open the dft file i created SE tells me...
I am trying to draw a simple sheet metal part and just can't seem to get it. The part is .024 thick, stainless. It is simply a horizontal line with a half circle, open side up,on the end or right side. The radius of the half circle is .1 and the part will be .625 wide. When I try to finish the...
