Hello everyone,
Could anyone help me understand what kind of effect would different fuels like TF1 E-10, TF2 M-5/E-2.5, Methanol 12%, Ethanol 22%, Hydrogen peroxide, Corrosive E-22 gasoline have on the precision ceramic (Alumina oxide 99%) balls used in automotive applications in a fuel tank...
Hello everyone,
Could anyone help me how to subject a part to prestress caused by 1000N tension force and then apply 10N cyclic loading(10N in compression and 10N in tension). The part is a hollow cylinder with side through holes. I want to model this in WORKBENCH 8.1 .Please help me out with...
Hello friends,
Could you guys help me with this analysis.
I want to simulate cyclic loading on a small cylindical hollow part with 2 symmetrical holes on its surface at the centre of the part. I want to constrain in all directions at one end and subject the other end to 50N in tension and 50N...
Hello Friends,
Could anyone help me find a way how to simulate modal analysis in loaded condition. How to do modal analysis on a pre-stressed model. For example there is cantilever beam fixed at one end and the other end is loaded by 100N force, can we find the natural frequency of the beam in...
Hello Everyone,
I would like to know wat kinda steel will be good( in terms wear resistance due to pitting of 440 steel ball on coin band) for a inlet tube which needs coining to seal a 440 steel ball sitting on the Inner dia of tube. Problem is the assembly leaks after 20,000 durability...
Hello Friends,
I would need ur help in inputting vibration test schedule data for my harmonic analysis. I have a fuel rail, I found the resonating frequencies. I have my vibration test data given as follows for parallel to bore(vertical)
Frequency(HZ) Accelaration(g)
20 3.3
500...
Hello friends,
I am doin modal analysis to get natural frequencies of a 450mm tube. I used Brick 8node Solid 45 and got the first mode frequency of 550Hz. Then I tried changing the element type to 20NODE Solid 95. I got the the first mode frequency at 460Hz. Could anyone suggest which elemnt...
Hello Friends,
I would like to make a cylinder behave as a rigid body (showing no stresses in itself when it hits another body). Please help me out in detail how to go about with this. Various methods would be good so that I have more than one way to do this. Thank u all for ur favor.
bye
Harid
Hello Friends,
I wanted to know wat values do i have to take for stiffness factor and friction in contact wizard to get my force required to cause the pressfit between a slug and receiver(fixed), I am trying to verify empirically and compare with ansys results. Could anyone explain all steps...
Hello ,
How can we avoid .tri file in harmonic analysis, my model is big that .tri file is using like more than 2,000,000kb memory. Please advise me.
Thank you.
Harid
Hello Friends,
How can we change the color options for mode shapes, I want to have undeformed shape and deformed shape different colors in modal analysis. Could anyone give some tips about this.
Thank you.
Harid
