Does a material condition applied to a datum or tolerance zone in a single segment of a multiple single segment position tolerance have to be uniformly applied to all like datums or tolerances in every segment? I know it does in a composite position tolerance, but I'm not sure about multiple...
I need to create a new part that is similar to a part that I have made in the past only the opposite hand (mirrored) and some of the feature sizes are different. It would save me a ton of time if I could use Mirror Part, but that gives me a derived part with all the external reference baggage...
Our IT dept. is finally getting around ordering new computers. They are planning on purchasing them with flat panel monitors. Because flat panels have a slower refresh rate than CRT’s, they asked if that was an issue with SWX. I haven’t run SWX with a flat panel, so I thought I would post the...
