Hi there
Not to sure on how to proceed on theis I have a worm gear with a 4 deg helix ( actually not a spring like helix) Just the 2 end faces are offset from each other by 4 deg in the z plane
Sort of like twisting each end
Its a shaft with the gear in the middle and the teeth of the gear...
Hello all
Sorry about this always seem to be asking , a bit one sided on my part .I have trawled through the achives , but no help hence the post
I have to agree with one post, for a re invented wheel . there is precious little info out there ! anyway
I need to size a small cross flow heat...
Hello there
the flywheel crank pin of my single cylinder engine, has a floating plain bush ie there is a solid bronze bush between the crank pin and conrod ....not in babit type as per car, modern bike...
But a large lump of bronze like a polo mint ( would be easier to draw a picture .....)...
Dear all
I am in the middle of selecting either a brass or bronze for a pressure /wear situation the pressure is around 350 Lb and the relative movement between the two is for a very short tine
I am wondering what the roles of Zn and Sn play when added for example if I choose a bronze with...
Hi there
Very sorry for this , I posted this already butfor some reason could not open the reply someone sent.
I have a single cylinder motorcycle engine . What I want to do is get an estimate of the frequency and loads ..the operating range is between 2000 and 4000 rpm
for the frequency I...
