I was wondering if anyone knew how to deal with the following problem.
I am modeling a simple rectangular prism (400x50x2) microns, and want to study the current density and skin effect of the volume when exited by AC voltage bias. I am using the SOLID117 element, with Keyopt(1)=1, which is the...
Hey All,
If I display the displacement of an object in a harmonic analysis in the results viewer, is the displaced shape the standing wave produced at that frequency? Or would it be something more like the superposition of the mode shapes around that particular frequency?
Thanks
Jonathan Lueke
Hey all,
Is it possible to have Ansys keep a load constant in a harmonic analysis? For example, If I have two loads placed upon the system, say a voltage and temperature load, and I would like to have the voltage load vary harmonically, while the temperature load stayed constant - would this be...
Hey all,
I am modeling a simple RF MEMS cantelever switch on Ansys, and I would like to be able to extract the current density off the model. Anyone have any ideas how to go about this?
Thanks.
Jonathan Lueke
Hey All!
I was wondering if it was possible to generate a model in which the parameters of a hollow beam's cross section could be varied, and then carry out an analysis. The problem is that the range of these parameters (length, width, thickness) is large. The easy and time consuming solution...
Hey all,
What is a ballpark cost for extruding a small aluminum block, no more than 50 cm long, 35 cm wide, and 20 cm wide?
Or better yet, is there an online handbook that would have this information (or something similar)?
Hey all,
What is a ballpark cost for extruding a small aluminum heat sink, no more than 50 cm long, 35 cm wide, and 20 cm wide?
Or better yet, is there an online handbook that would have this information (or something similar)?
