Search results for query: *

Is it possible to alter the program on this unit with the key in the "run" mode? Thank you, Afterhrs

Does anyone have the mean time between failures rate for a standard PLC-5 output card Thanks, Afterhrs

If I run across an SLC 5/04 and the program is password protected, can I remove the battery (wich hopefully cause the cpu to loose its program), and then re-install the battery. After performing the above action, will I be able to gain access to the SLC afterwards. Thanks for your help...

I am looking for a manufacturer of General Motors specification 436 stainless steel. Any help given would be greatly appreciated. Thanks, Afterhrs

I have noticed that the one thing that people in this forum like to discuss is QUALITY. There have been a few threads recently that address contactors. I am starting this thread so people may voice an opinion on the their motor and drive of choice. I am by no means an expert on the subject...

I am looking for the mechanical code that is the equivilant to the NEC(National Electrical Code). Specifically, I would like to the what mechanical standard or code is used to regulate industrial machinery. Thanks for your help, Afterhrs

I would like to the best combination for networking the following plcs: (2) PLC-5 (7) SLC-5/04 (1) MICROLOGIX 1500 Let me also say I am only looking to retieve data, not program remotely. I am looking for the following information from the...

I have dealt with NFPA 79 for several years , but now I keep hearing about UL 508 for panel building. Could someone please explain the difference between the two? Does this mean all components should be UL listed or do they have their own standard , like IEC and NEMA standards? Thanks for...

I am looking for an electrical auto cad program that is somewhat equivalent to Rockwell Automation's " RS wire " program. I like their program , but it is cost prohibative. Thanks

Can someone please explain why power factor correction capacitors pull so many amps when there is no or very little load on the busbar. Thank You, C.S.

Does anyone have the specifications for the clear plastic that covers the instrument panel for the speedometer, tachometer,and other gauges?

I would like to know what the grade and or specification for plastics used to cover the blue lights and red lights used on police and ems vehicles. A point in the right direction would be greatl appreciated!