Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: 00098
  • Content: Threads
  • Order by date
  1. 00098

    When to use metallic gaskets and alloy studs?

    Does anyone have a "rule of thumb" to determine under what general conditions to use metallic gaskets and alloy studs?
  2. 00098

    Pipe Hangers - Vapour Service

    What is the maximum recommended horizontal spacing between pipe supports for 30" standard weight steel pipe? I am looking at Anvil International catalogue PH 2002, page PH 207 which states 34ft. Unless I misunderstand piping design, I feel that the 34 ft is a "typo".
  3. 00098

    Steam Turbine Seal Losses

    Has anyone ran across a good book that states, or have a proven "rule of thumb" for estimating the average gland and labyrinth seal losses through an extraction/backpressure steam turbine. I want to use this number in calculating the net shaft power developed by the turbine. The...

Part and Inventory Search

Back
Top Bottom