Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations 3DDave on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. N

    Question on V-Loops

    Why do V-Loops have lower allowable pressures as size increases?
  2. N

    How to properly analyze a flange at a boiler in stress analysis?

    Does anyone have any insight on how to properly model a flange connection on a boiler? I was given nozzle loads and moments for a boiler that I am connecting to. I am running a stress analysis of my HW pipe. I typically model anchors as non rigid. allowing for roughly 1/16" of total movement at...
  3. N

    Pipe Crossing Building Expansion Joint

    Hello I am modeling a 16" HW pipe crossing a building expansion joint. There is movement in the X,Y, and Z direction. Due to both coordination & cost the owner does not want to use a product to take the minimal movement and instead wants the pipe geometry to take it. I believe this is fine. I...

Part and Inventory Search

Back
Top Bottom