Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Shahrukh_Islam

    What does Convergence Tolerances mean in Abaqus?

    Hello everyone, I have been asked about the parameters of convergence tolerances for Abaqus - RIKS analysis that I had. I have attached all the parameters to this image that I have used. Could anyone tell me if the "stopping criteria" is similar to "convergence tolerances"? If not, where should...
  2. Shahrukh_Islam

    Regarding Repetitive Monotonic Loading after Riks

    Hi everyone, I am trying to do a repeated monotonic loading and unloading after Riks analysis. I have done the initial unloading after Riks but am a little bit confused about the repeated loading and unloading. I did the unloading using Static General step post riks by using command prompt. My...
  3. Shahrukh_Islam

    Unloading in Riks

    Hi everyone, I am trying to analyse a beam by loading it to a certain point using a displacement controlled parameter. In this case I need to know the postbuckling behaviour, so I am using Static Riks. My question is how to unload after a certain point during the application of displacement...

Part and Inventory Search

Back
Top