Hello everyone,
I’m seeking clarification on a fabrication method for a ring-type flange with the following dimensions:
I.D.: 1100 mm
O.D.: 1250 mm
Thickness: 135 mm (no hub)
Material: A516-70
My fabricator plans to cut 75 mm-wide strips from a 140 mm-thick plate, then roll them into the...
Hello everyone,
I am designing a cyclone filter with a flat top though which a large nozzle passes.
The cyclone is working in full vacuum condition with zero internal pressure at a design temperature of 200°C.
The calculated thickness for both drum and conical section is 8 mm. Material is...
Hello everyone,
I’m a mechanical engineer working for a vendor that designs and fabricates heat exchangers. While we primarily focus on mechanical design, clients sometimes ask us to guarantee thermal performance as well. This usually involves minor tweaks in HTRI, like adjusting tube layouts...
Hi,
I have a problem understanding this clause from Appendix 13 of Sec VIII regarding the stress calculation for a rectangular vessel with more than 3 compartments. The part of the clause in question says:
13-9 (f) (2): "... For a vessel with more than two compartments, use geometry shown in...
