Hi All,
Is there any resources on typical architectural wall sections for tilt up's?
I'm building a house, and am concerned about moisture getting trapped between the panel and the drywall.
This may be more an architectural question, but interested to see typical details, and how to fit them...
Hi All,
Firstly, id like to say I'm sort of stuck with Bentley systems. Unless I put a lot of effort in to convince others, and will likely take a long time.
Secondly, I have used STAAD a little, but cannot get over the horrendous user interface / work routine. I remember the first time I used...
Hi,
I'm trying to design Deadman guy anchors, with significant uplift, and horizontal force.
A typical arrangement for a guyed dead anchor is to bury a concrete block at depth, then protrude an anchor rod to the ground line (this obviously causes a lot of ground disturbance, I'm not a fan)...
Hi all,
Was wondering if there was any resources on grout filled hollow section?
I have a high consequance of failure, steel power pole that was impacted by a vehicle causing a visible deformation. A buckling analysis indicates a capcity reduction of at least 25%.
The reduction in capcity...
Hi All,
Designing a Small, single story Tilt up building of mostly solid panels. The walls will be subject to both in plane and out of plane loads.
All design examples i could find seem to ignore this combined load case, they mostly design panels on out of plane loads and axial loads (ACI...
