After checking the ASME PTC4 Power Test Code for Fired Steam Boilers I could not found boiler feed water system balancing procedures.
How should the boiler feed water system be adjusted or balanced to prevent overflow pump conditions?
How to account for delivering proper minimums flows to all...
I am looking for a code (IPC 2003)interpretation regarding trap requirements. I am designing a plumbing system in a mechanical room which is completely independent of all the other building areas. The plumbing system consist of a network of floor drains and one sink all in the mechanical room...
What are the most important things to consider when designing the boiler room steam header?
Should velocities be the same as the boiler discharge outlet? Should the spacing of the discharge and inlet pipes be the same as pipe rack spacing? Should the header have a slope for draining of condensate?
Is it true that lowering the set point operation pressure of a boiler will give more efficiency with equal or more than rated capacity in lbs/hr?
What is the difference between lower than design pressure on a water tube and fire tube boiler ?
I have one 39,000 lbs/hr water tube and two...
I want to measure steam flow and temperature without shutting down the system. System is 100 psig saturated steam nominal three boilers of 1000 bhp each.
What is the best type of measurement devices for this application?
I have been looking for a good reference of Corrosion Rates for Metals that classifies the environment conditions (Atmospheric or Pressurized) and publishes the material loss / year with units of depth per time (i.e. micrometer / year or thousands of an inch / year).
So far the only thing I...
