Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: Harshu03
  • Content: Threads
  • Order by date
  1. Harshu03

    3D Induction bends

    Are the test bends to qualify MPS as per ISO15590-1 produced at the same angle that of production bends.. We have a problem of 3D bend produced out of tolerance of mentioned bend angle per requirement however the test bends for MPS were tested at different angles that of production bends.
  2. Harshu03

    ASTM F436M for M20 M30 washers

    Can anyone share material spec for M20 & M30 washers. I have a situation where I get deviation from the vendor to ASTM F436M for M20 & M30 washers..however i do not have the basis to chack if this is acceptable or not.Below is snapshot of the material certificate.
  3. Harshu03

    PWHT per B31.3

    Reference to Table 331.1.1, only PWHT parameters (soaking time, soaking temperature) where provided based on applicable thickness selected by designer. However, Table 331.1.3 provides exemption to mandatory PWHT requirements provided preheat of 95 deg cel maintained during welding when nominal...
  4. Harshu03

    2 piece side entry ball valve

    We have a 42" ; 2 piece side entry ball valve, 300# used for subsea application to be installed on PLEM. The question is for 2piece side entry ball valve which has a welded body, the welding point is potential for leakage..so how can it be avoided..the body is forged..and does the welded part...

Part and Inventory Search

Back
Top Bottom