Dear All
I hope that one of the materials experts may be able to help me.
One of our piping specifications uses 304 StStl ANSI 150 flanges (or more accurately ASME B16.5 A182-F304)
Our spec states that it is rated for 17.0barg pressure at up to 120degC.
My question is how do we get the...
From a safety point of view, how do we best manage working on (breaking into) the vent line downstream of a rupture disc or pressure safety valve. The application in question is on storage of a toxic liquid. Multiple tanks have safety devices piped to a common abatement device (wet...
A bit of a basic post with little detail to start off but here goes.
With a vacuum system, how can you estimate if there is a flammable atmosphere inside the vac pump.
I imagine it's a case of calculating flow rate of flammables removed, and amount of air leakage into the system. Then...
Dear All
We have a small packed column with id 750mm. Can someone please recommend how far into the column the temperature transmitter pockets should extend into the packed sections.
I would think the further they go in, the more the disruption to the liquid flow down the column (more...
At work we insert an earthed grounding rod - in through the top of a plastic IBC (1 tonne plastic contaiber) when filling flammable materials through the top.
Why is this done, and what is the benefit? It seems to me that it is the liquid itself that is being grounded to prevent a spark...
Dear All
Can anyone pass on some first hand experience of using descaling solutions to remove build up of rust/scale in reactor jackets or heat exchangers. I know that there are proprietary solutions available, but would also like to hear from people who have used more readily available...
I am looking at the likely build up in pressure inside an atmospheric storage tank when purging steam into the tank for instance to clean out a transfer line. Assuming 6 barg steam is used through a 1 inch line, then from a choked flow calc, I estimate that the max possible flow of steam is...
Does anyone please know where I can find an idiots guide or chart for selecting the correct type of pump. For instance viscous fluid consider rotary gear, viscous with solids consider rotary lobe, clean fluids conider sealles pumps, high flow or low flow etc. I am not looking at a specific...
Does anyone please know where I can find an idiots guide or chart for selecting the correct type of pump. For instance viscous fluid - rotary gear, viscous with solids - rotary lobe, flammble liquids, high flow or low flow etc. I am not looking at a specific issue, but just some general...
Hi
Could anybody please help me with when to decide if bonding of flanges is necessary for solvent pipework. Ethanol and IPA are the solvents in question. Is there a rule of thumb that if you keep the velocity low enough then no bonding is necessary. Thanks.
Hi
We currently pump a slurry from a tank at 3 degC through a bank of tubular filters. Product returns to the feed tank, which has glycol on the tank jacket. Product increases in temp over time despite this cooling. Recently the bank of filters was insulated - the idea being that this...
Can someone please advise me on material selection. The intention is to distil acid wash water consisting of approx 5% isopropanol and approx 5% sulphuric acid. I am currently considering reboiler and column in hastalloy C. The feed tank and recovered isopropanol storage tank also need...
