Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Datum Target
I have a print that has datum targets sitting next two linier dimensions. two pins in an assembly same size on a coaxial line. pin diameter is ref position to A datum targets are A1 and A2. this to me is not a valid way to apply the datum targets this is what I understand to be correct Datum...- rje2019
- Thread
- Replies: 16
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Datums coaxial A-B
Hi I'm trying to clean up Gtol prints for different engineers but I don't recommend changes until I have confirmed that the changes I recommend follow standard. I couldn't find this in the book specialty Ok I have an assembly situation this is what Eng1 has listed two bushings space 24plus...- rje2019
- Thread
- Replies: 6
- Forum: Drafting Standards, GD&T & Tolerance Analysis
