Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Correct English in quantity note?
I started my apprenticeship as a boilermaker about 15 years ago where I noticed qty notes on our drawings said "5-off" or "10-off", for example "5-off as drawn, 5-off opp-hand". I remember thinking this wasn't correct English, and should be "of" instead of "off" but it wasn't my place to comment...- ajcraig99
- Thread
- Replies: 8
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Australia and NZ GD&T standards
I am looking for a book on GD&T and am not sure if the ones that usually come recommended online will be suitable in Aus since they are based on ASME Y14.5-2009 which I don't have access too either. Is anyone outside of USA able to recommend a book and/or applicable standards that I can...- ajcraig99
- Thread
- Replies: 3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
