I am interested in using 1.25" x .120" wall square, seamless, 304 SS for a supply manifold on a system using heat transfer fluid. The reason is for ease of fabrication. Maximum temperature is 350°F, maximum pressure is 35 psig. I realize square tube is not intended for pressure and not sure...
I have a door that will open/close vertically. Cam followers will guide the door inside grooves in the door frame. On the door frame, I drew a sketch then a curve along the groove. (the groove in the door frame is vertical then curves inward at the bottom) In my assembly, I'm trying to...
First I will describe the setup. A 100 kva generator is operating a small ice plant. The voltage is 208 V/3 phase/60 Hz, Wye. The loads are as follows: 15 hp refrigeration compressor, 4 hp condenser fan, 1.5 hp pump, air conditioner (draws 24 amps) (all previously listed are 3 phase, 208V), (3)...
I have a finned cooling coil constructed from 304L stainless steel. It is installed in an oven that is operated at a temperature of 175°C. During the cooling cycle, chilled water is pumped through the coil. At the beginning of the cooling cycle, water is fed into the coil at the full rate of...
A 304 SS finned cooling coil is installed in an oven and is connected to a chilled water loop that operates at 50°F and 40-60 psig. The ovens are operated up to 165°C for approx 4 hours. Then the water is turned on for the cooling cycle which lasts approx 1/2 hour. The ovens have operated...
