Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Cast Iron Dilemma
I have a "1 off" class 40 casting that has a partial drilled hole (17/32) in the wrong location. The correct location only moves the hole about 100 thousands from the incorrect location, and I need the entire depth of the hole to be threaded. The partial drill is at most .25” deep and the...- maniacle
- Thread
- Replies: 8
- Forum: Metal and Metallurgy engineering
-
fuel injection and charge velocity
I was wondering if anyone has any quick tips or refferences to papers i might be able to find information on mixing fuel and air charges. Ive been told that below a certain velocity, i wont obtain an optimal mixture distribution and this could result in misfire, irregular flame propogation, and...- maniacle
- Thread
- Replies: 1
- Forum: Engine & fuel engineering
-
Gerotor Design
I am looking for any resources or tips regarding general gerotor design. I have found the Gerotor Design Studio software, but have been unable to run it on my system. Any assistance or advice would be greatly appreciated.- maniacle
- Thread
- Replies: 4
- Forum: Mechanical engineering general discussion
