Hello. Can someone check my model and see what I am doing wrong?
I basically have a rigid body at the top, liquid like material in the middle and a deformable body subjected to bending in the z direction.
The model is simple but it just won't run at all and is stuck at time 0.
I get errors...
Hello engineers. I really need your advice on my research.
I am trying to investigate the possibility of application of liquid based (gel or grease) non curing thermal interface material (TIM) for thermal management of electronics such as pcb, ap, etc.
The material would probably have a low...
Hello. I have a thin flat square shaped container that is welded around the edges and filled with water.
After welding it induces tensile residual stress approaching the material's yield strength around the weld seam.
When I pressurise the vessel to more than 2 bar, what is going to happen...
I am trying to initially constrain my model using MPC and then release node by node when the field variable switches from 0 to 1.
In the odb file I can see the FV changing from 0 to 1 but I am not sure how to use the field in the mpc subroutine.
In the subroutine mpc then field looks different...
I am trying to change the stiffness of connector elements using USDFLD as a function of time and coordinate.
When I run my model, it says no value for the connector elements for any output other than those available for these specific elements.
I wanted to change the stiffness with increasing x...
Hey All,
I am running a weld model on ABAQUS using DFLUX subroutine and wanted to request HBF (heat body flux) as a field output . However, since Flux(1) cannot be requested as an output according to the documentation (surface and element based loading output variables do not include...
