Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. TimMcK_Aero

    Using drawing tolerances as part of justification

    Hello, Discussion at work about using drawing tolerances for justification. I'd like to hear your thoughts / pointers to guidance material. Hypothetical Examples: An L-section extrusion had gouge damage on the bulb which has been blended out. 1) The dimension of the bulb is less than the...
  2. TimMcK_Aero

    Mass Balance requirements history

    Hey, Does anyone know of the history behind the mass balance load factors? e.g. (limit loads perpendicular to the control surface): MIL-S-5706, Para 4.9: 36g <= 9x(symmetric pull up load) <= 60g FAR23.659: 24g MIL-A-8870 Para 3.2.1.1.1.3: 100g Tim

Part and Inventory Search

Back
Top