Hi everybody!
In a contact analysis in Abaqus, you should always have a denser slave surface than master so you don't experience penetration. I found this picture to illustrate: https://www.sharcnet.ca/Software/Abaqus/6.11.2/books/gsa/graphics/gsx-pure-mast-slave-nls.png .
I use a 4-node...
Hi everybody. I'm doing a shear test of a pin. Today I stumbled upon an something interesting. With C3D20 elements, I get a stress of 710 MPa and with C3D8 elements I get 370 MPa. Even if I use finer C3D8 elements it will not get as high as 710 MPa. Anyone know a reason for this?
Pictures...
Hi everybody.
I'm a little stuck with a problem. I use a displacement boundary conditions applied to a reference node. It is very similar to what this video does: https://www.youtube.com/watch?v=soYwaW54WRg
The problem is when I use the same equation constraint my part doesn't move (nothing...
Hi Guys!
I'm trying to bend a pipe in Abaqus. I following this video: https://www.youtube.com/watch?v=soYwaW54WRg on my model in the picture attached. I'm using the block on top to bend the pipe underneath. The job runs and completes but nothing happens and I have the following error messages...
