Sometimes inside a sketch i get the "Selection Scene Bar" instead of the "Sketch Scene Bar".
I am not sure when exactly it happens (maybe if the sketch is fully constraint or not) but i found no option to force it to always be the "Sketch Scene Bar".
Any workaround on this? NX2306
Kind regards
This is a very basic example of such an issue where the defining spline has 2 redundant points or you could say split in 2 (i believe it originated from AutoCAD) but previous history is not available so there is no way to fix the spline other than re-creating the feature.
Is there a tool in...
I have a very very weird issue and i'm trying to see what is causing it.
So basically i'm running a system with a 5700XT, 19.12.2 drivers, win10 1909 and 2 displays (1x 1440p 10bit freesync over DP, + 1x 1080p 8bit over HDMI).
Second (aka the 1080p) monitor is run through an EDID emulator...
Hello. I am a little new to FEA, and i'm having an issue in finding a way to set up a constraint how i want to.
So here is this bracket
There are 2 pin constrains in the bottom holes and a force applied perpendicularly to the 2 holes above.
I can do a mesh and resolve the problem, no worries...
Hello guys. In the past i was trying to reverse-engineer a spline to use with some custom pulleys, and i couldn't get a standardised spline design to work. I was certain it was an involute spline but turns out it's not. I've checked ISO, BSI, JIS, DIN nothing worked. In the end i had my...
Hello guys. I am fed up. In the last couple of days i am trying to create a correct internal involute gear. A little background:
I have a power steering pump pulley that i happen to want to change some of the parameters. After i found the specs for the poly micro-v profile (PK belt) and reversed...
Hello. I have serious issues on designing tubing of different cross-section ends. Ok i know how to work the "Sweep along guide" and the "Tube tool" (of which is step-down tool of the previous tool) and i was able to make a really good transition from an oval/slot shape to a circle. These are...
Hello. I have a small question, which should be obvious to someone familiar with fabricating exhaust manifolds.
Regarding the exhaust port flange; Would you rather machine your flange to the OD of the exhaust header tube, pass it through the flange and weld it around on the skin of the tube, or...