Looking for a "felt-type" seal that would be stationary with a nylon piece somewhat compressed on the seal and cycling back and forth. The main objective of this seal is to keep fine dust from getting past the seal.
The seal material needs to be compressed, yet with a very low...
I curently have an ABS that is not performing well strength wise, and I am considering going to either a long fiber abs or even a long fiber polyester. The original material I used in this aplication was 33%GFN, and the warpage of this curved plastic part was unbearable.
I was told that the...
Can anybody send me in the right direction in order to design or purchace a hand tool that will install an o-ring into a bore that is aprox. 1-1/2 inches long to the o-ring groove. The o-ring cannot be intalled by hand due to the small size of the o-ring dia.
Thanks
I'm in the process of prototyping a part that will eventually be made in 380 Die Casting Aluminum. I will do some strength and endurance testing with this material and the best match I have found as far as surface hardness and yield strength is 6061 T4. Nobody seems to have this material...
I'm looking for a replacement for Durez 31906 Black phenolic. My problem is the lack of dimensional stability, and wear resistance after molding - both of which I have to improve. I'm willing to look at other phenolics, or even other MATERIALS all together.
Thanks for any suggestions!
I am a Project Engineer in a field similar to appliances.
I would like to tap into the technology of small appliances to increase my experience in my respective field.
I would like to attend a conferece or seminar on appliances to get a feel of design intent, etc...
Could somebody point me in...
