Search results for query: *

Greetings to everyone. At present, I am evaluating Steam turbine piping loads as per NEMA S23. The analysis is being done by using CEASAR II Software. I do not have past experience in dealing with steam turbines. I am seeking guidance from the subject experts regarding how to model the steam...

Greetings to everyone. At present, I am evaluating Steam turbine piping loads as per NEMA S23. The analysis is being done by using CEASAR II Software. I do not have past experience in dealing with steam turbines. I am seeking guidance from the subject experts regarding how to model the steam...

Why we are limiting variability of spring with in 25 percent. How does it affect if I choose a variable spring with variability exceeding 25 percent. Thanks in advance

For one of our new project we have tp put Calibration Pot at the pump( mechanical operated diaphragm pupms) suction and Pulsation dampener( volume type pulsation dampener) at the discharge. Could any one please gude me for sizing the Calibration Pot and Pulsation dampener to suit below...

Does any one have technical specification of long radius bends(made of carbon steel/alloy steel/stainless steel) which covers all inspection/design requirements? thanks in advance

what is the difference between axial stress and longitudinal stress in a pipe under internal pressure? i am always having little confuse between these two....eloborate explanation is appreciable

can chlorine di oxide transported through carbon steel pipe?

why in down stream to the orifice also straight run is required? thanks in advance

Why circumferential seam is not allowed in manfacturing of welded pipes?

GENERALLY WHAT TYPE OF ISOLATION VALVE USE FOR H202 SERVICE? IN MY PLANT I HAVE SEEN ONLY BALL VLAVES ARE USED FOR ISOLATION PURPOSE, WHY CAN'T WE USE GATE VALVE FOR ISOLATION? IS THERE ANY PARTICULAR REASON? IF SO EXPLAIN BRIEFLY....THANKS IN ADVANCE

I AM WORKING AS DESIGNN ENGINEER IN PETRO CHEMICAL REFINERY..I WOULD LIKE TO LEARN CAESAR II SOFTWARE..I AM REQUESTING THE EXPERTS IN THIS FORUM...HOW TO START? WHAT TO LEARN? RECOMMENDED BOOKS? RECOMMENED ONLINE SITES TO GET THOROUGH WITH PIPING DESIGN ASPECTS. THANS IN ADVANCE

In which scenarios we will prefer to provide bypass for GATE VALVE/GLOBE VALVE...WHY? THANKS IN ADVANCE

1.WHY BALL VALVES ARE PREFERABLE FOR H202 SERVICE...CAN I USE GATE VALVE INSTEAD OF THAT? ACTUALLY INSTEAD OF 3/4" BALL VALVE OF ASTM A182 GR.F 316L,TRIM-SEAT-RPTFE FLANGED END 150# I WANT TO USE 3/4" GATE VALVE SW BODY ASTM A182 GR.F 316L TRIM STELLITED.. IS IT OK? THANKS IN ADVANCE? 2. CAN...

what is the significance of Y coefficient in ASME B 31.3 PRESSURE DESIGN THICKNESS CALCULATION?

What do u mean self limiting stress? What is equivalent elastic stress? Thanks in advance

What will happen when air is entrapped in a centrifugal pump? And if air is entrapped in pipe line loop?

What are the lugs with respect to pipe supports? What is a shear lug

What is meant by non shock cold working pressure? What does it mean non shock

when and why annular plate is used in tank bottom plate?

what is the difference between removable legs and fixed legs in floating roof tank and advantages one over another?