Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Position tolerance of an axis?
Hello all, In your opinion can I give a position tolerance of an axis? I have defined the axis through 3 angles and one point (defined by 3 coordinates x-y-z), since this axis refers to a complex inclined geometry. So the next step would be the definition of the position tolerance on a...- tanner78
- Thread
- Replies: 5
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Captive screw
Hello, I am designing an item with 4 screws M6 fastened on 4 through holes obtained on aluminum bores (height = 12 mm) at the respective ends of a flange. I am evaluating the category of captive screws since for handling reasons I would like to tight the screws on the holes so as to keep them...- tanner78
- Thread
- Replies: 9
- Forum: Machines & Machining engineering
