Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Can't get path stresses??
Hello, I am using Ansys for mechanical analysis. When I read in an RST file and use SET command, I can get stresses along a path. But when I assign the results to an load case ID using LCDEF, I get 0 stresses along the path. Any idea what I am missing? -Al- AliGokce
- Thread
- Replies: 2
- Forum: ANSYS: ANSYS Software Suite
-
Cyclic symmetry setup in NX Nastran
Hello, I setup a rotational cyclic symmetry modal analysis run in NX nastran following the guidelines in the user manual. I can't make sense of the results. In F06 file, it gives a separate eigenvalue block for each harmonics starting from 0. I was hoping that Nastran would assemble solutions...
