Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Advice for this part please and a couple of other niggling questions - ISO/BS8888
Hi there guys, Just looking for some feedback/advice on the drawing attached. It's the spider component for a custom universal joint. The intent of the part is for the position of the 2 opposing spigots to be tied up nicely WRT each other and the level of perpendicularity of the 2 other...- ska7ch
- Thread
- Replies: 4
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
I have some very basic GD&T questions....working to ISO/BS8888
Hi guys, I consider myself to have a fairly good handle on GD&T (except for these little queries) and have been trying to implement it over the past few months, however got a couple of niggling questions hopefully someone can answer. 1.) Say you have a rectangular block with a size dim across...- ska7ch
- Thread
- Replies: 9
- Forum: Drafting Standards, GD&T & Tolerance Analysis
