Hello everyone
I have just started a new project on my own.Though there are numerous softwares to carry out suspension geometry analysis I always had an interest to do the same using matlab.
Project Goal :
To carry out suspension geometry analysis using MATLAB for an open wheeler car.The...
Hello everyone
I am designing a machine which has got two cylindrical hollow aluminum columns on its either side to hold the machine.For better understanding , I have attached a picture of it below.
My question is
A side load of around 1500 N acts on the column radially at half of its...
I'm in the process of building a shock absorber dynamometer.I have planned to use a 2 HP motor with a max RPM of 1750 for this.
But the required working range is from 20 RPM-200 RPM
1.Is it possible to achieve this using a VFD??
2.And kindly guide me whether to choose an AC or DC drive?? and...
Hi everyone
I am in the process of building my own shock dynamometer for racing applications. An overview of my design
1.Motor : 3 Hp,Single phase,220 v motor with a Max rpm of 3450
2.Mechanism : Slider crank mechanism with a setup to provide different stroke lengths ranging from...
I was trying to run a suspension analysis and in turn I get the following error in Adams/Car
Static equilibrium analysis has not been successful.
The maximum number of iterations 25, has been reached.
For the last attempted iteration:
The equation with the largest error was contact Comp = 5...
Can someone please state the important points to be remembered while building a suspension template in ADAMS/CAR??
Some tricks and tips for ADAMS/CAR template builder are also welcome :)
