Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Measure distance -tool keypoint filter default
The measure distance -tool on Inspect tab has a filter where it snaps by default (center and end point, end point, tangent, midpoint etc.) It used to be on "all" by default, at least in ST4. Now I'm using ST6, and the default selection is center and end point. I use this tool very much for...- jyk1
- Thread
- Replies: 1
- Forum: Siemens: Solid Edge
-
NX8.5 sketching and color related question
Hi, I've been using NX8.5 with TeamCenter few weeks now and I'm off to good start but I have a few questions: When sketching for example basic rectangle, I'm used to position it on the sketch using centerlines of the curve. For example in Solid Edge, the dimension tool is able to snap on the...- jyk1
- Thread
- Replies: 7
- Forum: Siemens: UG/NX
