Hi all,
I need to measure the temperature of a process fluid that is under 15,000psi and 400°F. I am looking at using a thermocouple in a thermowell, but I am having trouble finding something that is rated to that high of pressure. Any suggestions? I am not too picky for connections as we can...
Hi all,
I am back with another hot oil question...
I am looking for a pump that can handle the following:
1. Up to 200°C (could be a little flexible on this)
2. 2800-3000 psi output pressure
3. 3.0 gpm @ 1750 rpm
4. Ideally be able to run off a 5 hp motor @ 1750 rpm
5. Be able to pump from...
Hi all,
I need help choosing a accumulator or something else appropriate for my task.
I have a pumping system with approximately 5 gallons of oil in it. It is a closed system. When I run the machine the temperature goes up (200°C system max) and as the temp increases so does the pressure due...
I need to figure out what is in the picture highlighted by the red box. I think it is some sore of bearing assembly to support a rotor, but it looks pre-manufactured (whereas the silver part to the right is custom made). Any ideas as to what it is called? Where I can buy them?
Thank you all...
Hi all,
We have a piece of test equipment that has a hardened 440C stainless steel shaft with a 12 rms micron finish and a case hardness (about 0.080 depth) of about Rockwell C50-55.
I need to bring the surface finish to somewhere within 35-125 rms microns to meet the spec of a keyless bushing...
Hi all,
I have an analysis that I am having trouble on how I should approach.
I have a spherical pressure vessel with a known internal pressure and therefore a known potential energy. I am trying to figure out the amount of energy that is absorbed (from the potential energy) when the pressure...
