I have a disk with 5 holes in it.
The hole center is sloppy big, and largely uncritical. The 4 tapped holes, I want located around the center hole.
The tapped holes are not critically spaced to the center hole, but they do need to be critical in regard to the 4 holes in the pattern. (ie, the...
[/URL]]
What I have is two assemblies that share the same assembly drawing. The difference is the tapped hole. Assembly A uses a 1/4-20 bolt and washer, Assembly B uses an M6 bolt and washer.
So I'm looking at y14.34-2008, specifically around figure 4.
On one hand, it says every item...
See picture above(which hopefully posts)
I'm trying to use GD&T (Y14.5-2009) to tolerance the flats of the D-hole. What I'm trying to describe is the flats centered on the 1.125 diameter hole.
I also have to do something similar with the shaft that fits through this hole.
Position tolerance I...
http://i.imgur.com/VZW6KWA.jpg[/IMG]]
See picture above(which hopefully posts)
I'm trying to use GD&T to tolerance the flats of the D-hole. What I'm trying to describe is the flats centered on the 1.125 diameter hole.
I also have to do something similar with the shaft that fits through this...
