Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: shonuff
  • Content: Threads
  • Order by date
  1. shonuff

    API 12F Repair- crack

    We have a API 12F tank that has a crack on one of the top corners of the the clean out that runs through the weld and continues at a 45 degree angle approx 2 inches in the shell. CFR 195.205 (b) instructs to follow the standard by which it was built. I just don't see anything in 12F that...
  2. shonuff

    Hardness Test

    Had some scaffold boards that got hot enough during PWHT to smolder and possibly have an open flame. Boards were put out buy water hose. If I were to do hardness test on this pipe is there a specific way or layout of the test on the pipe?
  3. shonuff

    Looking for a way to check the dist

    Looking for a way to check the distortion of a RFWN flange. Would like to know different ways to perform this task but the situation at hand only allows 3 inches between flanges. Is there a tool specifically made for this job?
  4. shonuff

    Mineral wool insulation

    If the lines in the facility are heat traced what are the pros and cons of mineral wool and perlite insulation?
  5. shonuff

    Concrete moisture

    In general what is the acceptable moisture percentage in cured concrete?
  6. shonuff

    Liquid velocity

    Which code or standard provides the velocity rates for liquids in piping or a pipeline.
  7. shonuff

    LEAK TEST RECORDS

    Does B31.3 specify that leak testing records differentiate a unit of measure, psi or mpa and if so where is that located. Can't seem to put my finger on it.
  8. shonuff

    Lacquer coating on new pipe?

    Do pipe mills that manufacter standard carbon steel pipe, spray the pipe with a lacquer coating before shipping?
  9. shonuff

    Fire protection

    Can anyone suggest the proper code or standard to follow for plant firewater piping(psv, monitors, valves, etc) inspections? Would it be NFPA 25?
  10. shonuff

    NDT for socket welds

    Previously had socket weld(fillet)crack, analysis revealed the failure was fatigue due to harmonics. Changes are being made to correct the problem at other welds. Would like to know other than dye/pen what is another ndt method to inspect fillet socket welds to check for cracks??
  11. shonuff

    pump and motor maintenance

    Would like to know if there is a standard that addresses the intervals of maintenance for pumps and motors? How to determine normal or severe service?
  12. shonuff

    NBIC New Construction AI stugy guide

    Was wondering if there is a study guide for NBIC New Construction AI available for purchase. Haven't been able to find one as of yet.
  13. shonuff

    Allowable diameter of socket welds for different services

    Would like to know the restrictions, if any for socket weld pipe, in different services.

Part and Inventory Search