Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. nastynotion

    Vertical Text in Draft

    Hi everyone. I tried searching a bit around, but without any luck so far. I want to add text to one of my drafts that is orientated vertically, in other words that the text is rotated 90 degrees from standard orientation. I've tried this with Text Box but I am unable to figure out how to do...
  2. nastynotion

    Creating engraved text 'wrapped' around a cylinder

    Hi everyone, Hope you all had a great easter holiday for those of you who celebrate that. So like the subject specifies I'm interested in how you guys would go about this. Usually when engraving something I just create the text planar to the surface and extrude the text with 'subtract' away...
  3. nastynotion

    Changing the default user of Solid Edge

    Hi everyone, Sorry if there is an easy and obvious solution to this, I can't seem to find it however. Is there an easy way to change the default user of Solid Edge that pops up in the startup screen? Other than doing a complete reinstall of Solid Edge on the computer. The name I want to...
  4. nastynotion

    FEM-analysis using NX NASTRAN - Can't access results after solving .sim [NX 7.0]

    Hello everyone, So I am trying to perform a simple FEM analysis of a very simple disc using NX NASTRAN in the advanced simulation environment. I make a tetrahedal mesh, assign material, add a constrain for a fixed area and add a load. But when I solve the simulation, everything seems to be in...
  5. nastynotion

    Error message in basic Flow Simulation [CFD analysis] NX7

    Hey everyone, So I'm trying to learn to do some basic CFD analysis using NX 7.0, specifically on internal flow in a test model of a 90 degree angled pipe. My process is as follows: [ol 1] I open my part, pipe_test.prt Open advanced simulation environment Right click part in Simulation...

Part and Inventory Search

Back
Top