Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: Weinstein
  • Content: Threads
  • Order by date
  1. Weinstein

    reduce arrow's tail in drafting NX 7.5

    Hello All, I made a drawing and inserted a dimension in NX 7.5 on the chamfer dimension (3mm) I couldn't reduce the arrows tails, except for one side if I move the digit 3 toward the center. thanks a lot in advance
  2. Weinstein

    watertight connction between flanged tube and flangless tube

    Hello all, I have a flangless tube to install for a short time on a line and I'm strugling to make it watertight. I tried to make flanged connections where the flange is bolted to the line's flange and the other side is only a simple tube of the same OD & ID of my tube.so the arrangement look...
  3. Weinstein

    dimension on whole symetrical extrusion

    Hello, I'm using NX 7.5 and I have a little problem with dimensions. I would like to create a symetrical extrusion and be able to dimension the whole body and not only half of it. anybody knows how to do that? thanks a lot in advance. s.y.
  4. Weinstein

    Break view section in Drawing NX7.5

    Hello, I'm trying to create a break view section of a projection view. my problem is that I can't select the chain of curves around my projection. did this problem occur often and does anybody have a solution? thank you very much in advance.
  5. Weinstein

    Show part's CSYS in assembly

    Hello, I assembled two parts and I would like to constrain them using their CSYSs. is that possible? I'm using NX7.5

Part and Inventory Search

Back
Top Bottom