Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Offset Point Creation
My requirement is to create a series of Points or Datum CSYS using the same values each time (i.e. the same X,Y,Z coordinates away from the last Point or CSYS created). I have tried a couple of methods, with varying degrees of success, and I was wondering if anything could ber automated either...- plmtech
- Thread
- Replies: 6
- Forum: Siemens: UG/NX
-
NX 8.5 Assembly and Part Navigator Toolbars?
Just getting NX 8.5 set up and starting to test it out. I have configured the latest version of NXCustom to our requirements. I have noticed that the Part Navigator and Assembly Navigator toolbars seem to have disappeared. Is this as-designed or a problem with my configuration? These toolbars...- plmtech
- Thread
- Replies: 3
- Forum: Siemens: UG/NX
