Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
NX 7.5 Part Configurations
Hello all. I used to be able to make different part configurations in SW which would suppress or unsuppress certain features in a part. I have a part that will have tapped holes at the assembly level, but not as a component. In the past I would have two configurations of this part in the same...- mike734
- Thread
- Replies: 3
- Forum: Siemens: UG/NX
-
Sewing Sheets to Solid body
I've seen this discussed here many times but I'm not having any success sewing together a ton of sheets that are from an imported iges file of a vendor's component. I got the sheets to succesfully sew together using a tolerance of .05 but I still have a sewn sheet. When I look at the section...- mike734
- Thread
- Replies: 7
- Forum: Siemens: UG/NX
-
NX Extrusion Bend
Hello all. I have a straight extrusion in NX 7.5 solid modeling that I need to bend to a certain radius/angle. I saw a previous post about this but it didn't completely solve my problem. I would like to model a tool, a chisel for example, straight and then bend it to an angle afterwards instead...- mike734
- Thread
- Replies: 7
- Forum: Siemens: UG/NX
