Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: Komo421
  • Content: Threads
  • Order by date
  1. Komo421

    Adams tyre testing trailer model

    Hi all, I'm simulating a tyre testing trailer in Adams/view to determine the change in the normal force acting on three vertical load cells attached to the trailer. I have a problem where the simulation runs, but after a while one of the joints that act as the load cell locks up? Any ideas on...
  2. Komo421

    Adams/view model error

    Hi all, I was wondering if someone could help me I constantly receive this error when I want to simulate my model in Adams/view. Does anybody know what the cause of this may be? Thanx in advance. Static equilibrium analysis has not been successful. The maximum number of iterations 25, has not...
  3. Komo421

    Water circulation system with incorporated heat exchanger

    Hi all, Im looking to design a circulation system. Water through the system must however remain at room temperature as close as possible. For this I want to incorporate a heat exchanger that interacts with a computer program so that the whole system runs autonomously; the heat exchanger pump...
  4. Komo421

    Flow Rate Through a Manifold

    Hi I want to select a pump for a quenching tank that has an intake manifold with 12 smaller pipe inlets to the tank. The flow rate required at the discharge is 170 m3/h, two pumps are being used with one in standby. Is it possible to calculate the flow rate for each small pipe on its own or is...
  5. Komo421

    Size of driving gear

    Hi, Im designing a cart to transport heavy materials and the motor I want to use has a speed of 1440rpm with a gearbox ratio of 90:89:1 the driven gear connected to the wheel has 34 teeth and must have a speed of 60rpm, module of 4.2. How can I get the speed at which the pinion gear will run to...
  6. Komo421

    Reduced flow rate of existing pumping system

    How is it possible to determine a reduced flow rate for the purchasing of a new pump, as the old pumps do not have to supply the flow rate that they were designed for anymore, thus just wasting energy and water?

Part and Inventory Search

Back
Top