Dear all,
I'm trying to rate existing HE with the data as below :
Shell Type : BEU
ID shell : 37 inch
No. of shells in paralel / series : 1/1
tube OD : 0.75 inch
wall thickness : 0.083 inch
Tube pitch : 0.9375
Tube pitch ratio : 1.25
Tube layout angle : 90
tubepass : 2
length :12 ft
Tubes...
good day all.
so i have a separator with ID=42 inch and length=16feet.
so this separator wiil be used for separate 30MMscfd gas.
so we think to make the nozzle ID bigger.
Will this design work for that 30MMscfd flow?.
thx for any input for me.
Goodday folks
Hi all i need some help regarding ligting lug.
Im trying to design an padeye to lift 15 tons load.
but im having trouble to design it because my basic is not from mechanical.
Can someone review my design and give comment about it.
Did 1.55 inches thickness enough to lift 15tons...
Hi good morning all,
Im kinda new in using hysys and having a problem to make a hypothetical.
i Have 3 compound that i want to hypothetical but i having some issue with it
1. 1st compound(hydrocarbon gas) data :
Density :1.14 lb/ft^3 ( @ 150 psig & 85 F)
Viscosity : 1.04 cP...
