Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: lapuser
  • Content: Threads
  • Order by date
  1. lapuser

    Substitute for Rulon 142 for Linear slide bearing

    I am looking for a substitute for Rulon because of the cost and I am wondering if there is something that will accomplish the same thing without being so pricey. Application has reciprocal movement only without rotation and very little load of any sort. It needs to have good slip stick...
  2. lapuser

    3d cad files for sanitary/tri clamp fittings from 1/2"to 6"

    This is a question I posted here in 2007 and to this day still have not found a good answer. I am looking for 3d files from "Bradford" and "Alfa Laval" specifically or ones that use the same dimensional standards. These fittings are the "tri clamp" design and butt weld type typically used in...
  3. lapuser

    Connect a Faroarm to SE ST

    Curious to know if anyone has a way to connect a serial port "Gold Faroarm" to SE ST or SE20 for reverse engineering.
  4. lapuser

    Tapping .09 pure Titanium sheet

    I have been asked to bid on a job that involves drilling and then tapping 200 holes. Thread is 1-72 and material is Ti pure 7" x 5" x .09 plates. The tool rep from my supplier has recommended using form taps for this as distortion is not an issue here. What alarms me is recommendations like 2300...
  5. lapuser

    Quadro 2500m settings for cad

    This is a general question about best quadro card settings for cad cam. I chose to post this question in this group because it seems very active whereas there is no group for the VX-cadcam that I use. I am assuming there is commonality in usefull settings for all cadcam so here goes. What are...
  6. lapuser

    Looking for 3d cad files for tri-clamp fittings up to 6"

    Having trouble finding 3d files to design components using the tri-clamp style sanitary fittings as used in food service. To date all I can find are links to sites closed down, or links to sites promoting various flavors of acad addins for a fee. I do not use Acad so addins are of no use to me...
  7. lapuser

    heat treating 440c stainless steel

    I have a customer who has ordered clamp feet made of 440c. What he wishes to achieve is to have a corrosion resistant but also hardenable clamp feet for mixer motors in a salad dressing mfg facility. What I need is exact info on how to heat treat 440c to a state that is both hard and also tough...

Part and Inventory Search