Hi,
A very simple question. Is the picture attached sensible? (Parallelism of 0.05mm for surfaces that both have 0.05mm flatness tolerance)
Either way - please try to explain why.
http://files.engineering.com/getfile.aspx?folder=c22be41c-e1c1-4e73-bf93-49347073df69&file=Doc1.docx...
Hi,
This is a long time misunderstanding on my part..
If for instance I have an M3 DIN7991 screw - what are the dimensions needed for the countersunk part? same dimension as the head? i.e. 6mm x90 degrees?
Thanks
Hi,
We have a system that functions at ~10^-6 Torr. Two of the gaskets we use are an Indium wire of 1mm. One is 350mm in perimeter and one is 280mm.
Both wires are in a standard gland, and are tightened with 8 NC10-24 screws. Currently there's no torque specification for these screws, and I'm...
Hi,
I'm a bit confused as to how to define tolerances for four accurate holes pointing at a finite virtual point. (Picture attached)
I'd also like that their depth will be toleranced between each other.
What Linear and geometric tolerances should I define for such an application and how? I'm...
