I am trying to better understand the definition of "Continuous Weld". The main question would be if a start/stop location is allowed inside the length of a continuous weld.
The AWS definition (From A3.0) is "A weld that extends continuously from omne end of a joint to the other." Doesn't seem...
I have always been under the assumption that weld sizes (especially fillets) on prints are to be considered MINIMUM sizes, unless there is a specific note, etc. stating otherwise. I.e. if the call-out is for a 5mm fillet, an inspector would reject a 4mm fillet but not a 6 or 7mm fillet.
I was...
