Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. JadalbertWincent

    ASME- II - Part D - materials and max allowable stress values

    Hi everyone, possibly the question, I want to ask, is a quite stupid - Im sorry. Using ASME Code Part 1 section VIII (flanges) there are two values: Sa & Sb. These are maximum allowable stress value. And question: should (have to) I use the values from ASME -II-Part D materials instead Sa and...
  2. JadalbertWincent

    Interpretation of ASTM F3149-15 - determining m & y factors

    Hi everyone, Can someone explain me what does it mean when in the ASTM F3149-15 standard is written: "Selection of yield factor, y, based on 0.00085 cm3/min per inch OD". The problem is of interpretation "per in OD". Does it refer to a diameter [in.] or a OD circuit [in.]? A leakage goes thru a...
  3. JadalbertWincent

    Gasket with bars - what method of calculation.

    Hi, Is any method in ASME Code to calculate gaskets with bars? Or, should I use s. VIII (flanges) and add areas of bars to an area of a gasket? I dont think it will be correct.

Part and Inventory Search

Back
Top Bottom