Good morning to all,
I just would like to know, since in others softwares there's the possibility of running the algorithm step by step, does that possibility exist in ABAQUS? So I could run each line of the keyword on my command and analyse where the error occurs.
Thank you all
Hello to all,
This was the first time that happened. I ran a job, that aborted a while after, then I tried to open the monitor to read the status file etc, but Abaqus crashed down and turned off. It only happens with any job (I created others to test it out) of a specific model (I even created...
Hello to all,
I'm a beginner in ABAQUS and I'm trying to simulate micromilling in 2D on ABAQUS (6.10). Since it has large deformations and loss of material I opted using ALE adaptive meshing on the workpiece. I created the domain, but I'd like to create a Eulerian boundary region(line in this...
hey guys, I'm having a problem here and I hope you could help me.
What I'm trying to do is a 2D micromilling in ABAQUS Explicit. The geometry of the piece is a rectangle, and it'll be deformed by the tool. The thing is, I created partitions on the piece to associate each partition to a...
Hello people,
I'm a beginner in ABAQUS (learning since april) and I have a problem with contacts. I'm using surface-to-surface contact with two pieces, the one deformable being the slave and the other being the master. I'm always getting the warning "The slave surface nodes have much larger...
