Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: DNort
  • Content: Threads
  • Order by date
  1. DNort

    PID Tuning

    I am trying to tune a PID controller to control a motor via a variable speed drive. The vsd used is a siemens micromaster 410 and ramp up and down times are low (1.5). I cant seem to get the speed output to remain steady. When in manual mode it produces a perfect steady output but in automatic...
  2. DNort

    Step 7 - Encoder

    Hi I am trying to control the position of an encoder using step 7. I want the position to change when the set point demands it so if position 1 is 10 and position 2 is -10 this would activate a change? I tried using a comparator block but if the tird position is -20 this activates a change...
  3. DNort

    Encoder Position Step 7

    Hi I am trying to control the position of an encoder using step 7. I want the position to change when the set point demands it so if position 1 is 10 and position 2 is -10 this would activate a change? I tried using a comparator block but if the tird position is -20 this activates a change...
  4. DNort

    PID Control

    Hi can some one help me tune my PID loop so I can get my variable speed drive to produce a constant set point output.
  5. DNort

    Scada Recipe Function

    Hi I am doing a project where I control a motor using siemens plc, vsd and scada wincc. I want to have 3 different sequences and using the Scada recipe function call sequence 1, sequence 2 and sequence 3 at different times etc. how can I do this using the recipe function? I have the sequences...

Part and Inventory Search

Back
Top Bottom