Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: woodwood
  • Content: Threads
  • Order by date
  1. woodwood

    Fanuc G81 Drilling cycle

    Hi all, Just a couple of quick questions about drilling cycles. Firstly, is it ok to change datum offset during the cycle? See below, using G57, G58 & G59: G90 G57 G0 X-8.573 Y4.95 S3262 G43 Z50. H127 M8 G99 G82 R1. Z-1.55 F15. P500 G58 X-4.95 Y-8.574 G59 X8.574 Y-4.95 G0 Z50. Secondly, am I...
  2. woodwood

    Question about GD&T.

    Hello all. I've not had much to do with drawings that contain GD&T up until now, just because of the standard of drawings that we get, and I was after a bit of assistance interpreting a feature. In the sketch you can see two diameters, the larger one being datum A and the smaller one with a...
  3. woodwood

    Where to get info on changes from NX6 to NX7.5 (CAM mostly)

    Hi all, I currently use NX6 (mostly for CAM but a little modelling and drafting) but will soon be starting a new job where they use NX7.5. I'm sure I'll be getting some training or guidance on what the differences are when I start but I was hoping to do a bit of homework before then. Does...
  4. woodwood

    What do people use for tool database software?

    Hi all, We currently don't have any formal systems in place to keep track of our tools and backends in our milling workshop. Mainly because it's just never been done and it wasn't too much of a problem in the past, but now we are starting to acquire more and more tools I think it is time to get...
  5. woodwood

    What do people use for tool database management?

    Hi all, We currently don't have any formal systems in place to keep track of our tools and backends in our milling workshop. Mainly because it's just never been done and it wasn't too much of a problem in the past, but now we are starting to acquire more and more tools I think it is time to get...
  6. woodwood

    RFID tags to track tools and holders.

    Hi all, Does anybody have any experience of using a system like RFID tags in order to track/keep stock inventory of backends and cutter bodies. I've been asked to look into this but have not had any experience of it. One thought was pull studs with RFID tags in, not sure if they exist though...

Part and Inventory Search

Back
Top