Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Lewis Y factor calculations
Hello, I've been looking for a practical way to determine the Lewis form factors "Y" for gears. This factor is defined as Y=(t^2 x Dp)/6l, where t= tooth thickness at critical bending stress points, DP= diametral pitch, l= tooth length as measured from t to top of gear tooth. Reputable gear...- manster34
- Thread
- Replies: 5
- Forum: Gear and Pulley engineering
-
ProE Student Edition and Win2k
Hello, I've recently upgraded from winME to win2k. I have installed ProE Student Edition in Win2k. Installation was a snap, however I cannot get ProE to run, when I double click on the ProE icon nothing happens, any suggestions. Manster34- manster34
- Thread
- Replies: 3
- Forum: PTC: Creo Parametric (Pro/ENGINEER)
